PHSE Preheater for 130x130mm printed circuit boards
A preheater is necessary to avoid thermal shock on multi-layer printed circuit boards during finishing.
PHSE is a complete solution for finishing small and medium PCBAs. It has a heating surface of 130 x 135 mm and four TC connections.
It is highly reliable and unmatched in temperature accuracy and PCBA control so no component is damaged.
It has three operating modes:
Power Mode mode enables operation at a fixed power level with the possibility of using a protective thermocouple.
Temperature mode maintains the PCBA at a selected temperature, using a control thermocouple and, optionally, protection thermocouples.
The profile mode allows control of the PCBA heating rate using a control and protection thermocouple, without exceeding the recommended limit levels in each application. It has 22 customizable profiles.
Up to four thermocouples can be connected in any of the three operating modes.
- Details
- Maximum power - 800 W
- Adjustable temperature - 50 to 250 ºC
- Heating surface:
65 x 135 mm – 1 zone
130 x 135 mm – 2 zones
– Type K TC connector – 4 for control and protection
– Profiles – 20 (up to 6 steps for each)
- Setting temperature profiles - 3 profiles (2, 3 or 4 steps)
- Maximum working time - 50 min or unlimited
– ESD Safe – Supports ANSI/ESD S20.20-2021
– USB-A – Update firmware, graphics and profiles
– USB-B – PC communications
- Robot connector - Remote control
- Aux. connector – Connection to the console
– Pedal connector – Pedal connection (P-005) for heater control