PHNE Preheater for printed circuit boards up to 108x70mm
A preheater is necessary to avoid thermal shock on multi-layer printed circuit boards during finishing.
PHNE is a complete solution for refinishing small printed circuit boards, such as those commonly used in smartphones. It has a heating surface of 108 x 70 mm.
It is highly reliable and unmatched in temperature accuracy and PCBA control so no component is damaged.
It has three operating modes:
Power Mode enables operation at a fixed power level with the possibility of using a protective thermocouple.
Temperature mode maintains the PCBA at a selected temperature, using a control thermocouple and, optionally, protection thermocouples.
The profile mode allows control of the PCBA heating rate using a control and protection thermocouple, without exceeding the recommended limit levels in each application. It has 22 customizable profiles.
Two thermocouples can be connected in any of three modes.
- Details
- Maximum power - 300 W
- Adjustable temperature - 50 to 250 ºC / 120 to 482 ºF
- Heating surface - 108 x 70 mm
– Type K TC connector – 2 for control and protection
– Profiles – 20 (up to 6 steps for each)
- Setting temperature profiles - 3 profiles (2, 3 or 4 steps)
- Maximum working time - 50 min or unlimited
– ESD Safe – Supports ANSI/ESD S20.20-2021
– USB-A – Update firmware, graphics and profiles
– USB-B – PC communications
- Robot connector - Remote control
- Aux. connector – Connection to the console
– Pedal connector – Pedal connection (P-005) for heater control
VIDEOS
PHNE
PHNE preheater
PHNE
PHNE operating modes